Copper Plumbing Tips

Houses today are usually built with copper supply lines that bring potable water into the home. While copper is an excellent metal for this, in that it does not rust or decay, sometimes even the best joints eventually develop leaks, or lines need to be rerouted in order to move fixtures around. Copper plumbing can be a fun, interesting, and very rewarding do it yourself project for the handy home owner.
Following are a few tips to remember if you embark on a copper plumbing project:
1) Have the right tools: Copper plumbing requires a torch, sand paper, flux, solder, pipe and fittings, copper cutting tool, and a fire proof rag. Keep these tools in a special toolbox, so you will always have your plumbing tools on hand. This may sound like a lot of tools, but actually, the above is pretty much everything you need for this job, and purchasing everything mentioned above can be done for as little as $60.
2) Choose Mapp gas: Purchase a Mapp gas torch over propane; the torch runs hotter, and will help you get a more professional connection.
3) Always clean your fittings: Clean all fittings with sand paper – even if the fitting is new. It is imperative that you clean What Is A Plumbing Code? each fitting, inside and out, to remove any dirt or oxidation, which could prevent the solder from bonding with the copper.
4) Apply flux liberally: After you clean the fitting, apply a liberal amount of flux to both ends of the fitting (inside of the female, and outside of the male). Flux helps Hvac Industry Outlook pull the solder into the fitting, but flux burns off as the fitting heats up, so you have to start with a lot, or it will all burn away before you have a sufficient joint.
5) Clean the joint: Wiping the joint with a fire proof rag while the solder is still wet will clean up the joint, making it look at neat as it works.

READ  Reasons to Hire a Professional Plumber For Plumbing Drain Cleaning